are there different versions of MR03S controller board ?

y'all;
in order to have my MR03S use different brushed motors,
i have embarked on changing the fets on my MR03S controller board.

it has been a long and costly endeavour but
i have finally soldered a new set of fets (4) onto my
original MR03S controller board.

during this learning process i have come across different
versions of the MR03S controller board.

i had purchased a MR03S controller board to practice on. this separate controller board only had
pads for 2 fets and they were located on the bottom side of the board. unfortunately, i lifted
some of the copper trace on this board, and rendered it unuseable. i saved the pot
and servo motor for spares.

so i began to replace the fets on my original MR03S readyset car. the controller card
in this MR03S car had soldering pads for 4 fets, 2 on the top side, and 2 on the bottom side.
this time around, i successfully replaced the 2 existing fets, and added 2 more on the
other side of the board. i have tested this controller board and it is working, and there is
no time delay (approx .5 sec) when switching from forward to reverse !

so, after all this, i want to put out the following questions:
- are there different versions of the MR03S controller board ?
- if so, which version contains the soldering pads for 2 fets on top and bottom face
of the controller card ?

the controller board with the soldering pads for 4 fets (2 on top, 2 on bottom) is the preferred board to have for this modification, IMO...

unfortunately, i cannot post pics cause an error message is informing me there is no more room for
attached pics.

thank you for your help,
billp